Alternatively, obtain and wear a commercially available discharging wrist strap device,. After removing an electrical assembly equipped with ES devices, place the assembly on a conductive surface such as aluminum foil, to. Use only an anti-static solder removal device. Some solder removal devices not classified as 'anti-static' can generate electrical charges.
Do not use freon-propelled chemicals. These can generate electrical change sufficient to damage ES devices. Do not remove a replacement ES device from its protective package until immediately before you are ready to install it. Most replacement. ES devices are packaged with leads electrically shorted together by conductive foam, aluminum foil or comparable conductive material. Immediately before removing the protective material from the leads of a replacement ES device, touch the protective material to the.
Be sure no power is applied to the chassis or circuit, and observe all other safety precautions. Minimize bodily motions when handling unpackaged replacement ES devices. Otherwise harmless motion such as the brushing together. The following check should be performed for the continued protection of the customer and service technician.
Measure leakage current to a known earth ground water pipe, conduit, etc. Any current measured must not exceed o. If the provided plug does not fit into your outlet, consult an electrician for. Ask a question. Harman Kardon BDS specifications. Related product manuals. What is HDMI? An HDMI cable is used to transport audio and video signals between devices. BDS 5. Touching wires can cause a short circuit that can damage your receiver or amplifier.
Touching wires can cause a short circuit that can damage the receiver. Install the Batteries in the Remote Control 1. When an item is highlighted, a blue border will appear around it. The screen will change depending on your selection. The General Settings screen will appear.
Some simple information is needed to ensure you get the best experience from your product. If the screen remains blank, please wait 15 seconds without pressing anything and the system will automatically return to the previous resolution.
Press the down Cursor control to select Speaker Settings. Press the up Cursor control to highlight 3. Please select the best aspect ratio that fits your TV.
The Audio Settings screen will appear. Please select the highest resolution that your TV supports. Select to adjust general settings Select to adjust speaker configuration 6. Apply even pressure to both sides of the base and smoothly slide it off the speaker.
If possible, position the speakers so that the mounting screws not included; use size 8 can be installed directly into a wall stud.
If that is not possible, use optional wall anchors that are rated If the remote seems to operate intermittently, or if pressing a button on the remote does not SURROUND cause one of the buttons to light up, make sure that the batteries are inserted correctly.
Page 21 a process known as compression. If your TV does the volume so you can hear the quiet parts without the loud parts disturbing others. NOTE: not, the receiver will output bit color. Page Information Menu R 0. To adjust a different speaker, use the cursor buttons to highlight it and NOTE: Before using your new BDS system, be sure to set the speaker distances, as explained press the OK button.
The Level and Distance selection screen will appear.
0コメント